USER MANUAL MODEL 2110 CopperLink Ethernet Booster SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007 Part# 07M2110-UMRev. BRevised 3/5/10 An
10 4.2 LED STATUS MONITORS The Model 2110 features two top panel LEDs that monitor PoE output and Ethernet activity, and two bottom panel LEDs that
11 APPENDIX A SPECIFICATIONS A.1 ETHERNET CONNECTION • Two Ethernet ports 10/100BaseTX; 802.3af• Auto-Negotiating 10/100• Supports Flow Control (IEE
12 APPENDIX B MODEL 2110 SERIES FACTORY REPLACEMENT PARTS AND ACCESSORIES *Only required with optional UI power supply (08055DCUI) Copyright © 2010Pa
2 CONTENTS1.0 Warranty Information ... 3 1.1 Compliance...
3 1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2110 components to be free from defects, and will—at our option—repair or replace
4 1.2 RADIO AND TV INTERFERENCE (FCC PART 15) This equipment generates and uses radio frequency energy, and if not installed and used properly—that
5 1.5 SERVICE All warranty and non-warranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Retu
6 2.0 GENERAL INFORMATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and
7 Figure 1. Typical application When using a Model 2110, in conjunction with a PoE Switch, the user extends the 802.3af PoE and 10/100 Ethernet an
8 Figure 2. Model diagram (2110/PSE model shown) 3.1 CONNECTING THE POE AND 10/100BASE-T ETHERNET INTERFACE The shielded RJ-45 port is the Auto-MDI
9 The 2110/P, 2110/PSE/EUI-48, and 2110/PSE/EUI inject power on the data pair pins 1/ 2 (POE+) and 3/ 6 (POE-) of the connector labeled “PoE OUT.” Th
Commentaires sur ces manuels